| Step | | Procedure & Parts & Tools |
| 1 |
|
LOCATE THE DRAIN HOSES ON THE BACK OF THE MACHINE
|
| 2 |
|
REMOVE CAPS, PLACE HOSES NEAR DRAIN AND EMPTY MACHINE
|
| 3 |
|
LOCATE 13MM BOLT ON RIGHT SIDE OF MACHINE, JUST BEHIND THE BRUSH DECK. REMOVE WITH SOCKET.
| Ratchet-Socket metric 13mm |
|
|
| 4 |
|
LIFT THE TANK TO OPEN THE MACHINE
|
| 5 |
|
REMOVE THE CASTER AND ITS 2 ALLEN HEAD BOLTS FROM THE BRUSH HEAD SHROUD.
| Wrench-Allen metric 5.0mm |
|
|
| 6 |
|
REMOVE THE REMAINING ALLEN HEADS FROM THE SHROUD
| Wrench-Allen metric 5.0mm |
|
|
| 7 |
|
LIFT BRUSH SHROUD OFF DECK. IT MAY BE EASIER IF THE DECK IS LOWERED.
|
| 8 |
|
LOCATE WIRE DISTRIBUTION BLOCK NEXT TO THE BRUSH MOTOR. WITH SMALL FLATHEAD, LOOSEN AND REMOVE THE TOP WIRES.
| Screwdriver-flat tip |
|
|
| 9 |
|
LOCATE SOLUTION LINES TO THE RIGHT OF THE MOTOR. PULL THEM FREE FROM THE FITTINGS.
|
| 10 |
|
LOCATE COTTER PIN UNDERNEATH THE DECK. PULL TO REMOVE.
|
| 12 |
|
PULL DECK OFF THE SHAFT.
|
| 13 |
|
WITH DECK OFF MACHINE, PLACE ON WORK BENCH AND TURN OVER. LOCATE THESE SPRINGS AND REMOVE BY HAND.
|
| 14 |
|
GO TO THE OPPOSITE END OF THIS PLATE AND LOCATE THE HINGE. REMOVE THIS CLIP WITH A SMALL FLATHEAD.
| Screwdriver-flat tip |
|
|
| 15 |
|
WITH CLIP REMOVED, PUSH THE SHAFT OUT AND THEN LIFT THE LOWER PLATE OFF DECK.
|
| 16 |
|
WITH THE LOWER PLATE GONE, REMOVE THE 5MM ALLEN HEAD BOLTS FROM AROUND THE BLACK PLASTIC COVER
| Wrench-Allen metric 5.0mm |
|
|
| 17 |
|
REMOVE COVER TO GAIN ACCESS TO BELT AND PULLEYS
|
| 18 |
|
CHECK BELT FOR TENSION. SHOULD BE ABLE TO ROTATE BELT 90 DEGREES, AND HAVE ABOUT 1/2 INCH OF PLAY WHEN SQUEEZED.
|
| 19 |
|
CHECK TENSIONER. MAKE SURE ALL 3 BOLTS ARE TIGHT AND UNIT IS IN THE FULL FORWARD POSITION.
|